Friese Barkmeijer TjalkA ship that can only be sailed because a hydraulic package connected to the engine ensures that the bow thruster, mast lowering system, anchor winch, rigging winch, centerboards, and mainsheet winch function with the push of a button. A beautifully renovated tjalk suitable for an unlimited sailing area. Also where fixed bridges are located and the air draft is high enough for a ship with a lowered mast. A French adventure is also among the possibilities. The underwater hull was taken out of the water in 2021 in Woudsend at De Welle for, among other things, a paint job and inspection of the underwater hull. Invoice of €25,000 available for inspection. The complete ship, including the superstructure, side decks, freeboard, and underwater hull, was painted in 2022. Also new anti-fouling in 2022. Invoices available. Measurement of the hull in 2018. No duplications!! Hull report is available. In the winter season of 2017/2018, the ship was renovated by SRF, during which the following was done: -the entrance was relocated -new windows -new doors -new kitchen -boiler connected to the engine -new stove and refrigerator -new electric toilet and shower -new Eberspächer heater and heating -new floor -the hull was oiled at the height of the cabin -bilge pump installed in the engine room and cabin In 2015, all skin penetrations were renewed, all penetrations except the toilet were made above water. Manholes were made in the water tanks and these were cleaned. Because the ship is equipped with a hydraulic system, it is an easy sailing ship and can sail with a small crew. Despite these modifications, it is a good sailor and sails well into the wind. The ship is equipped with a steering wheel that steers well in high waves at sea. There is a choice setting on the hydraulic steering system that allows you to disable the backlash valve while sailing. The bear at the back of the ship was made by Doef Schinkel, a sculptor in Kampen. The hull is in good condition. The rigging is as good as new. GeneralOther: A real Frisian Tjalk! Out of the water in 2021 and fully painted. Also the underwater hull. . AccommodationBerths: fixed 6, extra 2.Other: In 2012, a new cockpit with stainless steel hatches was added to the ship, and the aft cabin was also fitted out. The floor was also raised. The water tanks were separated in 2015 into 400 and 600 liters, so that in the preceding and following year only the small tank can be used. The standing heights in the ship are as follows: Approx. 1.95 Entrance, Approx. 2.00 Galley, Approx. 1.80 Salon, Approx. 1.70 Hall, Approx. 1.70 Bathroom, Approx. 1.65 1st bedroom, Approx. 1.60 2nd bedroom by the skylight. Next to the skylight, the standing height is approx. 1.15, Approx. 1.15 Forward in the bow. Engine, electrical, waterControl panel: Victron multi controlWater tank & material: 1 tank of 600 liters and 1 tank of 400 litersWastewater tank & material: +/- 150 litersRevolutions counter: in the dashboardOil pressure gauge: in the dashboardTemperature gauge: in the dashboardOther: In 2002, a new Volvo engine was installed in the ship. The engine has a PTO to pressurize the hydraulics, but the hydraulics also have their own electric motor for sailing. Bow thruster (sidepower 2015) is 24 hp. Victron Quattro 12/3000/120 inverter/battery charger and Victron isolation transformer 3600 W. 2010, new rudder and new propeller shaft. RiggingOther: - 1 hydraulic and manual rigging winch Strikwerda, stainless steel, 3 rolls. - 1 Meissner mainsheet winch hydraulic and manual, self-tailing. - 2 hydraulic centerboard winches with dyneema lines. - 2 Meissner 41 jib sheet winches self-tailing, 2x reef winch on boom. - In 2001, a new mast socket was purchased. In 2005, the rig was renewed. -In 2006, the sheet winches were adjusted, the control can now be from the cockpit instead of over the foredeck. -2010, new centerboards of Iroko, transom tapered, new centerboard beams and heavier mast bolt. -New mainsail in 2011. Navigation and electronicsOther: Autopilot of the brand B&G has already been purchased, but still needs to be installed. EquipmentOther: Mast lowering system is also hydraulic.