JF ANDRE CROZET 46

Crozet, JF André plan, hull from 2008, first launched in 2012

Refit from 2022 to 2024


Aluminum construction + insulation (between 6 and 18 cm extruded polystyrene)

3 double cabins / 1 bathroom

Full keel with a draft of 0.85 m / 2.90 m

Waterline length: 12.30 m
Overall length: 13.80 m, extended to 14.70 by adding a welded aluminum bowsprit
Width: 4.40 m
Air draft: 17 m
Weight: 13500 kg
Ballast: 4000 kg

Water capacity: 600 L
Diesel capacity: 500 L

YANMAR 4JH4E 54 hp Diesel engine from 2012 - 2178 H – Major overhaul completed in 2024
3-blade bronze J-Prop propeller from 2015

New standing rigging
1 full batten mainsail Armor sail in hydranet from 2012 - 43 m² new mainsail halyard
1 genoa on furler Armor sail in hydranet from 2012 - 56 m²
1 Solent
1 staysail with 1 reef dacron from 2012 on snap hooks on the lower fixed stay - 27 m²
1 asymmetrical spinnaker
New genoa furler
2 poles
Lazy jack
Mainsail cover


Andersen winches 58 ST / 52 ST / 40 ST
Mainsail sheet rail on roof cap
Mast foot balcony
Electric windlass Lofrans Tiger 1200 W
Aluminum bowsprit added in 2023
Double bow + 1 rear bow
Aluminum gantry with davits
1 solar panel 45 W on gantry
Wind pilot course regulator (2012)
Rear platform
Folding cockpit table
Second steering station in the saloon
Fridge (new)
Gas oven with 2-burner stove
New SCHENKER desalinator (never used) Zen 30L/h 12V
4 kW Eberspacher air heater (recent)
Hot water tank
Electric marine toilet with black water tank
220 V shore power with battery charger
5 battery bank August 2023, Victron AGM 12 V / 165 AH



Electronics:

Durabook computer with Adrena standard V19
FURUNO GP32 GPS positioner (2012)
ICOM ICM 411 ASN VHF (2012)
NKE sounder (2012)
Lock / speedo NKE (2012)
NKE wind vane anemometer (2012)
NKE repeater (2012)
ICOM ICM 803 BLU transmitter/receiver (2012)
ICOM MA 500 TR AIS transmitter/receiver (2012)
FURUNO radar (2012)
NKE autopilot with gyro compass
External iridium antenna
Epirb beacon



Sanding, grinding, and painting deck, hull, appendages, and spars
Cleaning of all tanks (diesel, water) and all bottoms
Creation of a chart table
Creation of a third double cabin and a shower room
Creation of a wet weather gear closet
Complete refit of the large table in the saloon with storage
Complete interior makeover with plywood veneers and painting of the entire interior
New kitchen sink and faucet
Complete refit of the electrical circuit (new panels), mast cables, lighting, and plumbing
New mule's tail

Bathing ladder on rear platform
Offshore equipment (without dinghy)
New 75 m anchor chain, diameter 12 with length markers